Your air conditioning system can be reset at the Circuit Breaker located in your Electricity Meter Box as follows:
- Make a note or take a photo of the fault code on your controller if applicable before reseting your system.
- Ensure your air conditioning system has been turned off using either the Remote Controller or Wall Controller.
- Go to your Electricity Meter Box and only turn off the Circuit Breaker clearly labelled for your air conditioner (Example: A/C, Air Con, Ducted, Wall Split etc…)
- Leave the Circuit Beaker off for approx. 3 minutes and then turn the Circuit Breaker back on.
- Allow Unit to self-commission for approx. 2 to 3 mins for the reset process to complete.
- Turn the air conditioning unit on using either the Remote Controller or Wall Controller.
- There will be a delay start of approx. up to 5mins when you power up your air conditioner before your system starts operating again.
- Monitor system operation for any faults, if all ok no Service Booking is required.
- If unit faults again, please arrange a Service Booking and advise the operator of any fault codes noted on your controller or abnormal operation.
- Please do not operate your system if there is a fault.